Redbrickman
Printer Master
If you want to try out the new Prusa Ver 2.0 Slicer this is a good walkthrough on setting it up...
https://www.youtube.com/watch?v=qKBkSabxD6s
https://www.youtube.com/watch?v=qKBkSabxD6s
I do not have a 3D printer but I enjoyed this well done video. Dave makes the complicated seem easy.f you want to try out the new Prusa Ver 2.0 Slicer this is a good walkthrough on setting it up...
Yes, there are so many settings and parameters in slicing programems and all of them can have different names for the same setting, so a simple to understand walkthrough makes all the difference.I do not have a 3D printer but I enjoyed this well done video. Dave makes the complicated seem easy.
Dave needs to see from my side…then he might think different..Dave makes the complicated seem easy.
What are you skeptical about?I became a bit sceptical when I saw him coping the CURA Start/End Codes…
The main reason for my scepticism was Prusa 2 Slicer are well capable of producing their own codes or even using CURA settings, but expecting users to plagiarize them is a bit rich..What are you skeptical about?
me too...Cura might not be the "best", but it does everything I need,