Latest activity

I think Paul Roark has published various ink sets and the composition of different base fluids. I would stick to one of those approved...

Many thanks for noticing my post, Hendrik! If you don't mind me asking, are you saying that rather than start messing around with the...

Looks pretty good from the distance. Do you use dye or pigment inks?

Since the surface tension of the ink is an important parameter for the proper functioning of inkjet printers, it might be risky if you...

Hats off to @ThrillaMozilla! Your amazing photo earned Picture of the Week and is now showcased on our homepage.

Sorry, I'm three days late with this. I first posted it three days ago on an insect forum.

👍 I agree, they are after all very cheap and cheerful and probably performing within spec which is ±5%RH. It was just my OCD kicking in...

Those little meters are pretty darn close, after all the amount of discrepancy between them is nothing, besides when measuring filament...

Hey everyone, I’d like to share a small project I’ve been working on: ChromIQ – a macOS app that puts a graphical interface around...

Thanks for the info. TBH I had never considered calibration. Will check out the video later 👍 Like you the 3 cheap ones (Aliexpress)...

You could calibrate your hygrometers using the salt method. See this video. I've noticed that some cheap electronic hygrometers I...

Thank you and yes I have a couple of filament dryers. I also purchased some vacuum bags and a pump specifically for filament. So along...

Keeping your filament reasonably dry is the best way of getting perfect prints every time, I have printed with my filament at about 50%...

I just realised I said West of Melb in my intro. I meant East. West Gippsland. I know roughly where you are. A good mate of mine lives...

I am a hobbyist, so the volume of prints is relatively low. In these cases, one must look at the total number of final prints produced...