[Tool] ChromIQ – a macOS and Windows GUI for ArgyllCMS printer profiling (v3.13.0-beta)

[pharmacist]

Yes, but only for the profile generating process, not for scanning. That is done with it's own proprietary program and only patch by patch.

 

[rjanowsky]

Thanks. I will go with this target and make some prints afterwards.

@pharmacist

I made a profile with the recommended target set and printed some B&W test images. Visually and measured the prints are nearly dead neutral. For me, it's perfect!

 

[mavtop]

Yes, but only for the profile generating process, not for scanning. That is done with it's own proprietary program and only patch by patch.

sad to read this,

today i tried with windows 11, no good news, but i built an USB-A cable to use with my 100W power adapter to give enough power to the old USB-2.0 hub, when i linked the usb hub and tried the i1pro1 device all seem to work, after 3 minutes of attempts (to see if it was stable) it begins to give calibration errors (out of tolerance white from the plate) again.

So i have two i1pro1 that both seem broken.

 

[mavtop]

the first i1pro1 has worked a total of 3 hours, the second i1pro1 has worked a total of 36m

so both would be like new, for this i don't understand, in the weekend i will try my usual i1pro1 on my old mac notebook where i used it in the past.

 

[mavtop]

good morning @itsab1989

i have two questions,

- i have a profile generated with chromiq and read using the Argyll chartread inside chromiq (so i have the ti3 file inside the structure of chromiq profiles):
Is it possible for the chromiq engine showing the aspected/detected value/colors in the measure chart page for the ti3 without knowing which software created it ?

- (feauture request) if i load a project (in the create chart page) and then go to measure chart if it found that was previously measured (if ti3 file is present) it shows the aspected/detected values showing a box that tell that a calibration exists and will be shown the values/colors ?

or it works only using the chartread chromiq version ?

i suppose that the ti3 file contains the detected values for each patch