Hi!
I read quite a few posts on this forum before jumping into ink refilling. I have a problem I hope you can help me with. I did some searches here and haven't been able to come up with the posts I need, but I'm sure they are probably on here. I apologize for that.
I have a brand new Canon Pixma Pro9500 Mark II printer. I bought my ink and the chips for the black and gray cartridges from chubs380 on eBay (I believe he is here on the forum?). I successfully replaced the chip on the gray cartridge and refilled it using a syringe and putting it directly on the sponge. That was the only cartridge I had to replace so far.
Since then I bought a set of reconditioned OEM cartridges from chubs380 as well so I could have a set of full cartridges full and ready for replacement. I bought the ARC chips for the gray and black for the new set as well as a resetter. The cartridges were already reset and ready to fill according to the description, so I didn't do anything to them except refill them and install them. I am getting an out-of-ink warning on the matte black cartridge, and a low ink warning on the yellow and cyan. I told the printer not to warn me about ink levels. Now the matte black cartridge no longer has a light on, and the yellow and cyan still flash. Should I reset them? They are already full, so I don't know if that is good to do.
Tonight I plan to fill up the OEM cartridges that came with the printer, and maybe I'll have better luck with them.
Any suggestions would be greatly appreciated.
Thank you!
I read quite a few posts on this forum before jumping into ink refilling. I have a problem I hope you can help me with. I did some searches here and haven't been able to come up with the posts I need, but I'm sure they are probably on here. I apologize for that.
I have a brand new Canon Pixma Pro9500 Mark II printer. I bought my ink and the chips for the black and gray cartridges from chubs380 on eBay (I believe he is here on the forum?). I successfully replaced the chip on the gray cartridge and refilled it using a syringe and putting it directly on the sponge. That was the only cartridge I had to replace so far.
Since then I bought a set of reconditioned OEM cartridges from chubs380 as well so I could have a set of full cartridges full and ready for replacement. I bought the ARC chips for the gray and black for the new set as well as a resetter. The cartridges were already reset and ready to fill according to the description, so I didn't do anything to them except refill them and install them. I am getting an out-of-ink warning on the matte black cartridge, and a low ink warning on the yellow and cyan. I told the printer not to warn me about ink levels. Now the matte black cartridge no longer has a light on, and the yellow and cyan still flash. Should I reset them? They are already full, so I don't know if that is good to do.
Tonight I plan to fill up the OEM cartridges that came with the printer, and maybe I'll have better luck with them.
Any suggestions would be greatly appreciated.
Thank you!