Tried my first refill with a homemade refill tool. It failed due to the heat shrink tubing separating from the hypodermic needle base. Instead I just jammed the syringe base into the ink output port of the cartridge. Got it to refill but this didn't seal well. Picture has a cartridge ink port taking out of the cartridge to better see what's going on.
Afterwards I bought a 20 and 18 gauge tapered needles (refill tools) from OctoInkjet. Both fit through the slit in the back of the ink port. Is this correct?
Where should a refill tool interface with the ink port? What size do I need the refill tool to be?
Thanks for any help or insight,
Steve
Afterwards I bought a 20 and 18 gauge tapered needles (refill tools) from OctoInkjet. Both fit through the slit in the back of the ink port. Is this correct?
Where should a refill tool interface with the ink port? What size do I need the refill tool to be?
Thanks for any help or insight,
Steve