Recent content by lin

As I don't own Epson 1390, you can also google the term "epson 1390 fuse" for image. There are some picture showing where the fuse located. Then use a magnifying glass to search for the f1 f2 or etc and use an ohm meter to check the board fuse.

Because the faulty printhead likely to have burned the circuit board fuse, you will still print blank pages even if you install new printhead. So you need to either get a new circult board as well unless you know how to repair the circuit board fuse.

the fuse f1 f2 etc is located at the printer circuit board. Generally, what happened is the printhead burnout and cause the fuse on the circuit board to break. As the circuit board fuse break, it causes the printhead to print blank pages even if you eventually replace with a new printhead...

The profile was good enough for me except that like I was mentioning above that I find it a bit dark. I was comparing with normal light like one would as they were holding a photo and not those professional light box. I tried to hold it under direct light (near to the light source). I still find...

coming back to this. Since the first icc profile the seller created is a bit dark and according to you guys and the seller who does not know how to edit icc profile once it has been created, that would meant that I need to get the seller to re-create a new profile. I would have to pay a second...

Thanks for your input. I guess then I probably would have to get another icc profile created if needed.

Hi May I know if ICC profile that has been created by Xrite i1 publish pro 2 can it be edited? I've gotten someone to create an icc profile for me. I asked whether he/she is able to help fine tune the icc profile he/she had created for me to be just a little brighter (less dark). But he/she...

adjust the platen gap for thick paper to see if it help reduce the scuff marks. Check the bottom of this redrivercatalog webpage where it mention for R2000. http://www.redrivercatalog.com/infocenter/tips/inkjet-printer-paper-thickness-platen-gap-adjustment.html

That randomly printing swatches of color that appear in whatever you print or even when you just merely print a nozzles check, is due to the golden pin on the printhead cable not inline with the printhead connector/motherboard aka circuit board connector or the cable golden pin is...

Hi, Just a question, have you ever remove the printhead from the printer to perform external head cleaning before? And is this printer purchased as first hand and not second hand/used from someone?

pearlhouse, have you try calling USA Service/Parts department to check if the printhead you wanted still have stock? I would avoid buying from china unless I really don't have a choice because majority from china are actually refurbished but seller claimed as new. If the seller do sell any...

There is a PW sensor underneath the printhead carriage. The optical sensor might be block by accumulated ink that prevent it from attempting to detect the edge of the paper to position it for printing. You need to reach to the bottom of the printhead carriage to find out where is the pw sensor...

jtoolman, have you tried the PremierArt Print Shield spray? I prefer PremierArt Print Shield spray over Krylon as I find PremierArt Lacquer to be pretty light weight compare to krylon. Unfortunately I could no longer find PremierArt in my country.

Your pdf nozzle check is due to the golden flat pin of the printhead cable is not inline with the golden pin inside the printhead. Unplug the printhead cable from the printhead and re-insert the cable to the printhead, ensuring the white printhead cable golden flat pin is well inserted deep...

pharmacist, Thank you so much for the info. Recently gotten the resetters. I should have gotten a chip resetter instead of the auto reset chip long time ago. Didn't know that the resetter work for aftermarket chip and even auto reset chip. Drive me mad with the auto reset chip, after resetting...