Worst print ever!!

[Tony4597]

This is the worst looking print I have ever had. Of course over the last years I have produced my fair share of poor quality prints, all traceable to lamentable mistakes by the user

Attached images first one with text, this side on the printer bed, second viewed in print orientation

Not sure what has caused this but while I have some thoughts anyone care to throw in some ideas

Printer Bambu P1S
0.4 nozzle
Filament Bone colour mnfctr unknown via Amazon
Uncalibrated filament using Bambu labs settings for their PLA
Speed ludicrous mode

I bought this filament to use to print a dinosaur head and stand and worked perfectly well on that project and on others including a grid infinity base (this is/was for the top).

Not worried about best quality and being an impatient so and so I did set the printer to Ludicrous mode. A mode that I have only flirted with in the past; I normally print standard mode.

After seeing the failure I printed again on Sunlu red PLA without issue, although I am not sure if I altered speeds

What do you think?