I use Inkjetcarts and have refilled the Photo Black ink once and now on the 2nd refill after resetting it is not working. Here's what happened; I did a mat black print last night and today when I tried to print a glossy it automatically would change inks from mat to photo black but there was not enough ink in the cart to make that change. I refilled the cart, reset it and it showed full. The R3000 went ahead and did the change but when I did a print it came bad. I did a print head check and the photo black is did not print. I proceeded to do a cleaning cycle and then another check and still the photo black did not print. I manually switched over to mat black and did a check and also did not print out. Switched back to photo black, again did not print. I can see the ink level has gone down about an eight of the full level so the ink is going somewhere but not on the paper.
Can anyone help???
It is late here on the east coast USA so I will return here in the morning, also I have about 30 more prints to do by Saturday morning for my presentation...
Could there be air in the line, if so, how do I get it out?
After switching and cleaning several times, I have used about 1/2 of the photo black and mat black ink in the carts...
Thanks for any help that I can use
Can anyone help???
It is late here on the east coast USA so I will return here in the morning, also I have about 30 more prints to do by Saturday morning for my presentation...
Could there be air in the line, if so, how do I get it out?
After switching and cleaning several times, I have used about 1/2 of the photo black and mat black ink in the carts...
Thanks for any help that I can use