printer refill numbers - was 983 refills, now 1,853 refills. much thanks to this site and its members

[Ink stained Fingers]

I can't compete with those record refill numbers - I enjoy the convenience of printers with a CISS or large cartridges - 220ml - for one refill

 

[The Hat]

It’s not the journey that counts, but getting there is.
Treasure all these old printers, their like will not come again...

 

[barfl2]

Thanks PeterBJ for your information will get a new battery to be on the safe side.
it would also enable me to check the stock of empty alleged Magenta carts I got off E-bay they looked spotless.

You can always rely on expert help on this Forum.

 

[barfl2]

If a battery powered original redsetter behaves like this with only a short flash but no long flash, it is normally a sign that the battery should be replaced. I suggest to replace the battery to avoid chips being ruined by garbled data being written to them.

I have had a few chips go bad possibly caused by a redsetter running low on battery.

The PGI-520/CLI-521 redsetter uses around 5mA during a reset. To test the CR2032 cell in a realistic way with a simulated load the cell should be tested with a voltmeter in parallel with a resistor of 3.3/.005 = 660 Ohms. Use a standard 680 Ohm 1/4 W resistor.

The use of a high input impedance voltmeter without load resistor in parallel might lead to a false good indication. More about resetters and batteries in this thread.

 

[barfl2]

Further to PeterBJ's advice re batteries on Redsetter confirm I have installed a new high-quality battery. Now all the carts get the short and long flash.

Thanks again

 

[PeterBJ]

Thank you for the feed-back.

 

[The Hat]

I still have an old (2008) iP4500 semi-retired, that I use from time to time because it’s not good for high quality photos, but still acceptable, it has the original print head in it and has clocked up over 54,000, I wonder is that a record for an original print head...

 

[PeterBJ]

It might well be a record. The original print head in iP4500 was QY6-0067. IIRC I read on the druckerchannel.de Canon forum that this print head had a reputation of being fragile. The fact that a replacement type, QY6-0075 was introduced makes me think it's plausible that the original print head was fragile.

 

[The Hat]

@PeterBJ, I have just opened the printer and checked to see which one is installed, it’s the 0067 model, so thankfully I got the fragile one...

 

[jimbo123]

54,000 pages on a print head is amazing, congrats !

i just checked my numbers and looks like i usually get 20,000 - 22,000 on an 830 print head.

i do have a brand new 4500 stored away, bought it in 2008 for $99 so to get an extra set of PGI5/CLI8 carts for my 830.

the 4500 is one the best canon printers as far as build quality.

J

------------------------------------------------------------------------------
• Active Printers: MP830, MP980, PRO-100
• Stored Printers: MP830, IP4500, MX700, MX860, MX870
• Method: German Durchstich Method
• Ink: Hobbicolors and OCP
• Misc: Squeeze bottles - so much easier than syringes