Nevidio
Print Lurker
- Joined
- Jan 24, 2014
- Messages
- 1
- Reaction score
- 0
- Points
- 2
- Printer Model
- Epson Sx 125
After desamling and cleaning scan component on my epson sx 125, my printer can not start.
At the first time i was unable to turn it on. After reconect cables again, my scan lamp and mechanism go crazy. On start up lapm turns on, go left, go back to home position, but motor dont stop, and belt vibrating. Loud noise from scan belt and motor mechanism. Three led lights blinking.
Adjustment program showing general error - something about scan home position error. I reconenct everything few times and clean white tape and black sqare to recognize home position, but no help.
I try to perform initial settings but at the and of initialization there is a message> The main board can not be used.
When I turn Off, print head correctly go left, then to home position
Maybe because this adjustment program is for TX121. My printer is sx125.
Now when I start adjustment program there no more information about scan home position error, but everything is same. Printer Dont work.
Any suggestion...
At the first time i was unable to turn it on. After reconect cables again, my scan lamp and mechanism go crazy. On start up lapm turns on, go left, go back to home position, but motor dont stop, and belt vibrating. Loud noise from scan belt and motor mechanism. Three led lights blinking.
Adjustment program showing general error - something about scan home position error. I reconenct everything few times and clean white tape and black sqare to recognize home position, but no help.
I try to perform initial settings but at the and of initialization there is a message> The main board can not be used.
When I turn Off, print head correctly go left, then to home position
Maybe because this adjustment program is for TX121. My printer is sx125.
Now when I start adjustment program there no more information about scan home position error, but everything is same. Printer Dont work.
Any suggestion...