Is it time to flush these Cartridges?

[mikem65d]

I spent virtually an hour plus searching for this answer, and as usual came away from the search with added knowledge from topics posted.
I did not find an adequate answer to my maintenance program so i hope you all forgive me for posting this especially if it is somewhere in this board.

These are out of my Pro 100.
I also have a I6600D for photo printing and just set up a used 6600 for my office. When i filled the cartridges i had prepared for the 6600 and looking at the one currently in use for the other i see full saturation from top to bottom in the sponge area.

The CLI-42 carts from the Pro 100 however are only saturated along the bottom. Does the picture show a normal fluid flow?

 

[The Hat]

Mike, the answer is in the cartridges themselves, if they are preforming satisfactory then leave well enough alone and just keep on refilling them.

The CLl-42 will double up for the 6600 printer, so you don’t have to keep separate sets of cartridges for both machines..

 

[mikem65d]

thx.....all is working fine.