Error 131B and 1410 on Epson Stylus 11880

Bitblab

Print Lurker
Joined
Nov 14, 2026
Messages
2
Reaction score
0
Points
1
Printer Model
Epson stylus 11880
Hey yall would appreciate sone help. So i have a 11880 that i havent really used in a while, did a nozzle check. a clean, and a print like 2 months ago. Turned it on today ran a nozzle check was having paper loading issues then the printer did one of those auto cleans and after the clean I got an error 131B. Turned it on an off a few times and got a 1410 error. In the past i got these error and eventually i updated the firmware and the issue went away for a while but now its back.

Anyone have Experiance with this that can help me out plz?? Thanks
 
Those two codes together after an auto-clean usually point at the ink system rather than a simple paper-feed fault. On a machine that sat unused, I’d inspect the capping station, wiper, pump tubing and waste-ink path for dried ink or a stuck pump, and check that the waste-ink tank/counter isn’t near its limit. Repeated cleaning cycles can make it worse. Since firmware only masked it before, a service manual or status sheet would help confirm the exact code definitions before replacing parts.
 
Those two codes together after an auto-clean usually point at the ink system rather than a simple paper-feed fault. On a machine that sat unused, I’d inspect the capping station, wiper, pump tubing and waste-ink path for dried ink or a stuck pump, and check that the waste-ink tank/counter isn’t near its limit. Repeated cleaning cycles can make it worse. Since firmware only masked it before, a service manual or status sheet would help confirm the exact code definitions before replacing parts.
Those two codes together after an auto-clean usually point at the ink system rather than a simple paper-feed fault. On a machine that sat unused, I’d inspect the capping station, wiper, pump tubing and waste-ink path for dried ink or a stuck pump, and check that the waste-ink tank/counter isn’t near its limit. Repeated cleaning cycles can make it worse. Since firmware only masked it before, a service manual or status sheet would help confirm the exact code definitions before replacing parts.
so i need to do a big print job. The error went away for now now that the printer had time to cool down. It was getting the error on boot up at first. I know the clean cycles make more heat than a regular print. I was thinking of trying to print a 58”x 36” black and white ( like 70% white) on canas and see if i still get error. But im afraid im going to make it worse.
How do i get a status sheet? Also i was reading that soaking the print head in distilled water could help. Are there any simple things i can do to try cleaning the dry ink before changing the the part?
 
Back
Top