Hi all,
This is my first post on this forum so hello to everybody and thanks in advance for your replies. I have 10 Canon IP4500s each with CIS attached which I use predominantly to print CDs/DVDs. They have been working like a charm up until recently. When I attempt to print any disc which is maily one solid block of colour (it seems blue or colours made up of blue are the main culprit) it will print correctly to within 1/4" of the top of the disc leaving the remainder printed unevenly or with lines (usually red). It starts getting 'liney' and progressively gets worse so that the top 1/4" is almost a solid block of colour (red mostly). I have tried multliple head cleans/deep head cleans to no avail. If the printer is rested for 1/2 an hour or so it will print two or three disc fine, but then reverts back to the behaviour above. It happens to all ten printers and they start doing it within a few prints of each other. Help.....!
Kojak
This is my first post on this forum so hello to everybody and thanks in advance for your replies. I have 10 Canon IP4500s each with CIS attached which I use predominantly to print CDs/DVDs. They have been working like a charm up until recently. When I attempt to print any disc which is maily one solid block of colour (it seems blue or colours made up of blue are the main culprit) it will print correctly to within 1/4" of the top of the disc leaving the remainder printed unevenly or with lines (usually red). It starts getting 'liney' and progressively gets worse so that the top 1/4" is almost a solid block of colour (red mostly). I have tried multliple head cleans/deep head cleans to no avail. If the printer is rested for 1/2 an hour or so it will print two or three disc fine, but then reverts back to the behaviour above. It happens to all ten printers and they start doing it within a few prints of each other. Help.....!
Kojak