pro9500

Hi everyone, I've been a lurker here for over 10 years and have really benefitted from your expansive knowledge. So thank you! I just picked up a used Pro9500 Mark II for $70. Physically in very good order. Not showing much signs of wear, and the previous owner says it was just used for...

Hello, my printer worked and then I accidentially sent 2 print jobs at once and now the blue and orange led flash alternating together with the error mesage 9200 but grayed buttons for canceling the print job. The printer is not doing anything anymore, the printhead does not move and the...

My nozzle check printout shows a stubborn problem with MBK despite a lot cleaning, cartridge changing, etc. The best I've managed is the partial printout. The blank one is the most recent. In between, however, I was able to isolate the MBK cartridge and print from it nearly perfectly. I'm not...

Here's a sample of my nozzle check pattern. Half of the PBP is printing at partial density. I've cleaned the head with ammonia and compressed air, run several cleaning cycles and one deep cleaning cycle. Normally, I keep my 9500 turned on when not in use but I discovered recently that it had...