x64's latest activity

You need to enter the 'recovery mode' before you write can write the firmware. This guide on reddit describes the process, looking at...

I am shocked by what I'm reading, designing a board like that is downright malicious in my opinion. Not providing service tools to...

Hello, The last few months, I have been banging my head against the wall trying to reset the ink absorber count on my Canon MG2450. I...

I can confirm that the stock Ender3 KE (same extrusion and hotend) does print PETG great. I've never used ABS myself but I know it can...

You can typically use pigment inks in dye printers and vice versa, but there’s plenty of variables that could cause issues or even break...

Well then, my praises of Brother aged poorly it seems :lol:

The sensor on that board might be broken, maybe there is some other broken part somewhere, honestly could still be many reasons. If I...

You can check the list for supported instruments on Argyll, recently got a ES-1000 and had no issues calibrating and profiling using GUI...

I don't have anything to add other than that I am amazed and impressed by your persistence, and I am watching as a spectator. If you...

Just glue wouldn't repair the broken traces, but you could potentially repair this board by adding bridge wires to the solder points...

OrcaSlicer is a fork of Bambu Studio, which is a fork of Prusaslicer. I tried Orca when the scarf joints were introduced, and I was...

Generally speaking I would think a printer in the same series/time frame could share the same display unit, as it would be way cheaper...

It is really up to experimentation with the unknown solution and raw materials the factory uses. As far as I understand it pigment inks...

I doubt it would be worth your time, as much as I love to use and maintain retro hardware sometimes you got to bite the bullet and move...

As far as my knowledge goes, water based print ink commonly has a very slight amount of biocides as an additive to prevent mould and...