Recent content by Stuart21

Clean the sensor strip - naptha (lighter fluid) or metho, Then print ten or 20 pages, se if any improvement -

Make sure you buy new. Refurbs are risky. Alibaba or Aliexpress might be ok - check seller feedback. Often, the new heads are removed from (new) dismantled printers, if they guarantee that, should be ok. Give your pinter a full hydraulic clean (make sure lines flow cleanly). If not, a fine...

5 months? That would waste a lot of ink. What I would do with mine (Epson L1800) is remove the prinheads, flush with RO water or suitable head cleaner, blow out and leave dry till I need to use it again. Computer off, printer off. (I Have found that some solvents can dissolve the guts of the...

This lot (http://ufoprinter.com) make a flatbed base for the A3+ Epsons like the L1800. I have a similar base made by another Co which I think has 'gone'. ;-( Epsons seem to be pretty versatile - I use an ecosolvent ink in mine which prints quite well on hard (white) plastics such as ABS. But...

This may not be your problem, pharma, but I have found that with the Epson L series, if the plugs are not pushed down hard into the fill ports on the ink tanks, after filling, they may not seal, then it is not uncommon to find splotches on your work. If using carts, make sure any plugs are...

I would guess you guys are all talking about for water based inks. What about e.g solvents for cleaning ecosolvent ink printheads? TIA from Thailand.

You'll just have to get your dog busy!

Thanks all, but still no print - but it does appear to be an electronic / software problem. Test print, head check, print anything, not one pixel! iWIC status report shows ??? Also, have deleted & updated firmware, just same version etc as before Grateful for any insights / advice! Stuart.

LCD Temperature Sensor This fan or that fan is largely irrelevant. Just get one of these boys (a few $) & locate the sensor ACAP (As Close As Possible) to extruder, etc. Then you can change fans till the cows come home, & if all else is the same, you can rate the fans performance, & also find...

Thanks ISF. I bled all colours a couple of days ago, except yellow as it was fine. This was the test at the start - (two runs shown here together, 2nd one is the lower) so you can see it was not too bad - actually close to good. But now it is exactly zero! Not one jet firing! Very unlikely to...

Ink valve open -

Also deleted and reinstalled printer in (software updates) system preferences - same nothing.

Thanks, ISF. These are the screen shots that seem to be relevant. Test print - goes through all the motions, but prints absolutely nothing - not a single jet firing. All 4 tanks have ink, minimum is abt 8 mm above 'low' mark. Not sure why iWIC is showing all colours 'UNAVAILABLE' ??? Have run...

'so I ran a couple of (test) cleaning cycles'