samboy's latest activity

OK it does all that, but what error message are you getting on your screen, and how many times do the LED lights flash ?..

The round EJ slit disk film area is your problem, (Paper eject encoder error) LED flashing 17 times, it could be dirt on it or the...

If you’re having trouble getting the screws out, then dremel the unit off and repair it and then glue it back into position with a two...

Thanks Hat! I think you are right. The little board that has the slit that read the disk appears to be broken. I need to get that out of...

Actually, the orange light blinks 17 times in total and I think the white light starts and ends it with intermittent flashes.

The light still flashes through 16 cycles of white/orange. What would keep the thing from sliding all the way down the bar?

Ok, so I don't think those clear disc's have anything to do with my issue. I lined them up, and they are remaining in the same...

Hi - I tried to plug in and turn on the printer with the cover off, and I immediately received an error. Is that because the wifi is...

Ok, so I put it over my head and shook and could hear any loose parts. Should I give it a once over with compressed air? Should I glue...

It seems like it just has sticky stuff holding it on. I put it back on and had to bend the little boot that it spins through 2nd picture.

Ok, so I managed to get the top cover off. First thing I noticed was the ring off the spindle in the picture attached.

I have experience something like the movement in the video. In my case I stopped the print-head by hand before it went back under the...

The print head on all the Canon printers never gets confused on the positioning of the print head on the carriageway, unless the timing...

I'm not sure what kind of linear encoder strips (Canon) printers use, but I'm almost certain they are of the incremental kind. They...

You need to disassemble it further. If you want to repair your printer you have to go deeper anyway. Again I'm not with the printer so...