Recent content by refilldude

the clp 315 is not refillable...dell 1320c all day long better than the samsung and yopu can pick up a set of toners for 50 which do 2000 pages a piece... definatly dell 1320 if you was brave the refills take 5 mins and it costs 3 for the toner an 2 for a chip...obviously x 4 cartridges so...

check the transfer belt and the life left on the fuser first

can i ask what company sells this and for how much/....

not possible, sorry these are the same as the canon pg40 etc..no reset available.. just use them and ignore empty warnings

i have also seen a jero jig that refills this cartridges through the sponge so theres no need for a hole

ive always used candle wax...its easy to remove after aswell when refilling for 2nd time round

as long as the cartridge chamber has ink in it a you have auto chips it will reset the ink volume.but it would be pointless not to refill as the printer would think it has more ink thank it actually does. the chip is the first indicator that says the cart is empty the second is the prism. a led...

this is the case if you have replacement chips which are auto reset chips. if they are oem chips they need reseting

in the meantime try looking for instructions for reseting the waste counter as this is the same section of the eeprom reset and is alot more popular than what you are after

yeah ok.. the mp6xx and mp9xx ranges have the same sequences...ill get back to u if i find out more...can you even get into the service mode. as i heard the new canons service modes had been disabled but can see them doing it myself

no i dont think so... why would that matter plz

if you reset the epprom all values will be returned to factory apart from a couple like purge and cant remember the other. if you have the wrong sequence it just wont work. it wont damage the printer

try this its for a close model but from experience canon resets are family orientated 1. Unplug the printer for at least 2 minutes from the wall. 2. Plug the printer back in but leave the printer turned off. 3. Enter Service Mode a. Hold Stop/Reset button and the Power button for 5 seconds...

have a look at this...not my work http://www.nifty-stuff.com/forum/viewtopic.php?pid=29158

ok fair enough updating the firmware may do the trick but i doubt it. normally with canons you need to follow a procedure to enter the service menu. not sure for this model but its summet simple like hold a button power off then do a button sequence. but as i said not sure..ill have a look into it