Recent content by max-damage

Hi Last few days I tried to reset my RX585 using adjustment software, but unsuccessfully. Every and each time its giving me error 2100012C ? (check the screenshot) So far I tried: compatibility mode, set to XP I have tried using Epson RX580 , RX590 and RX595 adjustment software I have tried it...

Hi Im looking for Epson Stylus Photo 810 & 830U adjustment software Since these modela are old, I cannot find it anywere, please someone if has it PM me ! Many, many thanks ! UPDATE: I have found 830U, so I need for 810, thanks

I will update first post for future search.

Update: I have tried that, nothing :(. So I ordered a new motherboard, now the printer is working perfectly :D , cost of new motherboard is big but it is worth since 1400 is rare edition. thanks

Hi Many thanks for replay. I dont quote understand, basically i need to put one catrige, press ink button, close lid, wait, than press ink button again and put second catrige ... repeat process ? pls, correct me if Im wrong ? I will try that and post some replay

I have tried to disable Status monitor, same thing, I think this monitor doesnt affect the problem because when printer is not connected to PC , "ink" lamp is on, so it cannot recognize ink with or without PC. I have updated post. thanks

Thanks for replay As you can read in post, n.4., I have tried EPSON refillable cartridge with ARC (witch I have previously tested on epson P50 - working), same problem :( Also, I have tried to replace CSIC (not CISS), same problem :(

Hi Im owner of Epson photo 1400 inkjet printer for about year. Using CISS all time. Yesterday, suddenly printer refuses to recognize ink cartridges (all of them). Red lamp is lighting for ink. So far I have tried : 1. Tried pressing CISS button several (in ink change process) 2. Tried to turn...

Hi Did you managed to solve problem with CISS not recognzed by Epson 1400, I have same problem, please help. Many THANKS !

Thanks for links. definitely I will try to replace capacitors... here in Croatia it is hard to find capacitors in local shop so I will order some from ebay. I will post results here. thx

I didnt replace capacitors, I will try to do that next week, also, what are possibilities that switch transformer is out ? is it normal to have clicking sound from it when the switch transformer is good ? many thanks

Hi I have been reading manual yesterday, id doesnt say anything about power supply, only where is located :( I dont think the capacitors are bad, maybe ?, i have mesaure voltages rates on all three of them, voltages are fine but I dont know hot to measure capacitor I forgot to tell, when first...

Hi Thanks for replay. There are no signs of bad capacitor, i have inspected them all http://en.wikipedia.org/wiki/Capacitor_plague Large capacitor is 400V, i have mesaured voltage on in while the power supply is connected to AC, multimeter is showing me about 320V, but when the power supply is...

Ok, there is three fuses on board :D I have check them with multimeter, all three are fine

Hi Yesterday my artisan 700 has stop working suddenly, just powered off in the middle of printing proces. I cannot turn it on, no power at all, tried to hold power button, nothing :(. So I disassembled it, my suspect was the power supply has gone bad. When I hold "on" button, Im hearing strange...