Many thanks for the link. We'll look at it in detail. I do have a general question about mounting the print head on majic bullit. Some say it's not a good idea and others say otherwise. This morning we only had the light black missing a few spots and we thought we might do the above mentioned...
Again, thank you so much. If we get this going, we too will run it weekly. We're still not getting perfect nozzle checks on the black and light black. We'll work on it again tomorrow and see what happens.
We really don't know what is going on, but this morning we did another power clean and a head clean and it's giving us decent nozzle checks all the sudden. We'll work with it some more and see if we continue to get good readings. We appreciate your help very much.
I forgot to mention, there were a few air bubbles in the lines after re-seating the dampers so I ran an initial fill. The bubbles never moved during the process which gave me the indication that ink wasn’t being pushed through the head. Also, it didn’t look like there was any appreciable use of...
Thank you for your response. Our problem goes further than dampers I think. For over a month we haven't been able to get a good nozzle check. We've head cleaned, power cleaned and initial filled and still no results. We finally changed the dampers and we were getting pretty good nozzle checks...
Hello, This might sound like a pretty stupid question, but I'm replacing my old dampers and I have a question. I took one damper out and noticed a spike in the print head. Does the nozzle that goes into the print head have a seal on it? Should I remove the seal before inserting it? I'll need 7...