Recent content by Forsakyn

Thanks, appreciate the recommendation. I'll be ordering one by the end of the week, and will let you know how it works out (their 24" cut length model).

I've been looking to get a rotary paper trimmer (probably around a 20" cut length). To state the obvious, I want it to be extremely accurate, and I don't mind spending two to three hundred if necessary. Do any of you have any particular brand preferences? I've been looking at Dahle, Keencut...

Great, thanks for the information. Much appreciated.

Hi gents. Thanks for the prompt responses. As for more information, I'd like a minimum of 13" wide. I don't necessarily need water-resistant, but naturally it's something that would be preferable if it doesn't add a huge amount of cost. And while I stated ~$500, again, I'll go higher if that's...

Hi folks. I'm looking for a graphics printer that ideally can do double-sided printing. I haven't done a lot of research on this, so I figured I'd do a search for printer forums, and this came up and looks like a good forum. Ideally I'd like to pay no more than $500 (since it's coming out of my...