First run a nozzle check. If you have no magenta, then after the printer sitting a few hours, try another head cleaning. If you still get no magenta then your printhead is either clogs up, or you are not getting the ink to it.
Since it was working before over USB when I had the other cartridge in, I would also suggest trying another USB cable and/or usb port first, then completely uninstall and reinstall the printer driver, and also see if the printer itself displays any error messages on it.
Yeah, that looks a lot like a torsion spring from a paper sensor or guide. If it's not feeding from the rear tray anymore, that was probably the reason. I would not try to force it and find a service manual or teardown video of that particular model to show you where it goes.
Hello, All!
My new Lexmark printer setup is driving me crazy! It is not finding my home Wi-Fi connection even after resetting printer and router!
Any ideas??
I've even been standing right next to the router with the printer!
Help please....
If it's improving, even if gradually, I would leave the deep cleans alone. You could also try a Piezo cleaning cartridge for the black channel only before writing the printhead off completely.
If the error continues even after you’ve installed a new maintenance cartridge, you can try removing and replacing the maintenance cartridge. If it continues, then the printer isn’t detecting the maintenance cartridge and it could have a faulty sensor.
Since you are experiencing this before the printer even completes its startup sequence it will likely not be a fixable issue with a firmware update or reset. Having already addressed the cables it is likely the failure is either the scan unit or the main board.
20% isopropyl alcohol is a bit on the strong side to have sitting for extended periods, though. It may degrade seals, inks, and adhesives over time and is also harmful to ink jets over the long run. I'd use the manufacturer's recommended fluid or cap solution when ever you can. Also weeks...
Since the problem occurred over both USB and wifi, it sounds less like a connection problem and more like a printer hardware problem. You should print a nozzle check and see if any of the printer's maintenance have piled up. I mean, you have already seen error 308501 anyway.
If the blank lines always occur in the exact same location then you probably have clogged or broken nozzles in your print head. First I would perform a print head soak and use only genuine Canon ink. If performing the soak and using Canon ink has no effect on the nozzle check pattern then you...
If the printer sat unused for years, there's a good chance the printhead is still clogged internally. A replacement printhead would likely fix it, but unfortunately there's no guarantee. I'd post the nozzle check pattern as well, as it can sometimes reveal whether it's a clog or an actual...
If the automated cleaning routine is not successful then clear the cartridge contacts and perform a nozzle check. If the print quality is still not up to scratch you will probably have to replace the print cartridge or printhead.
Usually 5011 errors are due to the carriage or a sensor. Check to see if anything is in the path of the carriage or if there is any ink around the sensors or cables.
If the print job just vanishes and no errors report, then Mac OS X is likely still trying to communicate using the wrong protocol or an abandoned print queue. I would reset the print system on the Mac and then add the printer only through Epson's own driver (avoid the AirPrint drivers). Verify...