Latest activity
-
CConradH replied to the thread Possibility to convert csv-file with only L*A*B* values into a ArgyllCMS ti3 file.Perhaps I should start a new thread, but I wanted to put up some test results on my CM30. It's obviously a CM30 by color and function...
-
-
CConradH reacted to Tony4597's post in the thread 8 vs 16-bit printer drivers and 8 vs 16-bit workflows with
Like.
I tend to both agree and disagree about 16 bit printing and what it may bring to the table. Most experts I have had any contact with... -
palombian replied to the thread Anyone using the PRO-310?.Chroma Optimiser was introduced by Canon on the PRO-10. This removed most of the objections against pigment ink on glossy papers, PRO... -
palombian reacted to pharmacist's post in the thread QUIZ: How Well Do You Know Your Print History? 🖨️ with Like.
I've got 10/10....but I have to made a dedicated guess at question 8 But actually the last question there is something interestign...
-
AAndrewF replied to the thread Pixma ip7250 strange error after replacement of print head and mother board.I was aware of the dreadful design that may cause bad print head to damage motherboard and bad motherboard to damage print head so I...
-
HHogwild replied to the thread Pixma ip7250 strange error after replacement of print head and mother board.It sounds to me like the "new" print head or motherboard may be bad. A quick Google found these: Canon Pixma iP7250 has died. Checked...
-
AAndrewF posted the thread Pixma ip7250 strange error after replacement of print head and mother board in Canon InkJet Printers.I have replaced both motherboard and print head of a totally dead printer, placing also new cartridges before power on, but happened...
-
AArtur5 reacted to Redbrickman's post in the thread Anniversary update on Standard Lamp Mark V.. with Like.
No the Ender 3V3 Plus is not locked to a proprietary slicer and can run Cura. it also runs a version of Orca as far as I'm aware.
-
Redbrickman replied to the thread Anniversary update on Standard Lamp Mark V...No the Ender 3V3 Plus is not locked to a proprietary slicer and can run Cura. it also runs a version of Orca as far as I'm aware. -
CWelcome.. Sounds like you’d be a man to have a good natter and a few pints with of an evening at the local pub.. Life’s too short to...
-
HHungTR reacted to pharmacist's post in the thread A basic guide (see post #1) to setting up ARGYLL CMS profiling on your computer with Like.
Modern RGB printers are pretty linear in behaviour, so there is not much difference between 325 and 480 patches, but for shadow details...
-
pharmacist replied to the thread A basic guide (see post #1) to setting up ARGYLL CMS profiling on your computer.Modern RGB printers are pretty linear in behaviour, so there is not much difference between 325 and 480 patches, but for shadow details... -
AArtur5 replied to the thread Anniversary update on Standard Lamp Mark V...Do you mean that you can't use Cura with the new printer ?. ( On second thoughts that's maybe a .blessing.. :D ) Seriously, if this...
-
Tthebestcpu replied to the thread Computer can't recognize my Epson 3880.Not sure about the grey for reporting the color ink levels. I found this on the web to check: Confirm via Epson Printer Utility Open...
-
AAlan Baily replied to the thread Computer can't recognize my Epson 3880.Thanks for the info. I was able to make a test print. Is the info on the test print important or should I, as suggested, just go back to...
