Latest activity
-
OHi everyone,I’m hoping someone has encountered a similar issue. My printer has started printing poorly. I’ve noticed artifacts appearing...
-
-
MMikefromherts reacted to PeterBJ's post in the thread Canon PIXMA G4511 - dreaded 5B00 error with
Like.
It might be possible to reset your printer without the use of a service tool. See this thread and this. In case a service tool is needed... -
MMikefromherts replied to the thread Canon PIXMA G4511 - dreaded 5B00 error.Thank you, that's great ! I was following the instructions I'd seen previously, and from the manual which I've now downloaded, and it...
-
MMikefromherts replied to the thread Canon PIXMA G4511 - dreaded 5B00 error.Thanks ! Will give them a try.
-
pharmacist replied to the thread Possibility to convert csv-file with only L*A*B* values into a ArgyllCMS ti3 file.Yesterday I reprinted the target in a smaller size so I can read it with my i1 pro and generated a ti3 file and hoping to paste the... -
pharmacist reacted to Ansellbe's post in the thread Mickey mouse and Donald duck with their friends with Like.
All four characters were printed with Kingroon PLA filament. The 3D printer is Bambulab P1P and A1 with AMS.
-
PPrinceMorissette replied to the thread Canon PIXMA G4511 - dreaded 5B00 error.Thank you so much. Great!
-
Nifty reacted to Ansellbe's post in the thread Mickey mouse and Donald duck with their friends with Like.
All four characters were printed with Kingroon PLA filament. The 3D printer is Bambulab P1P and A1 with AMS. -
AArtur5 replied to the thread Mickey mouse and Donald duck with their friends.Are you endorsing spam.. ? :oops::p
-
AArtur5 replied to the thread Printers with built in automatic 24/7 cleaning cycles?.Not all printers are the same. Even within models of the same brand there're huge differences sometimes. I know for experience that...
-
Mhello good people, I have a Canon Pixma G4511 (4-in-1 scanner/copier/printer (and fax - at least I remember what that is for...))...
-
AAnsellbe posted the thread Mickey mouse and Donald duck with their friends in 3D Printed Project Showcase.All four characters were printed with Kingroon PLA filament. The 3D printer is Bambulab P1P and A1 with AMS.
-
-
PK Project Manager reacted to The Hat's post in the thread Picture Of The Week (POW) Information and Submissions with Haha.
No excuses, strive for protection… :ep Must do better... :bow -
PK Project Manager reacted to Redbrickman's post in the thread Picture Of The Week (POW) Information and Submissions with Like.
@The Hat If you knew where I was perched and the time I had to snap that shot you might think differently ;) Anyhow, centred shots are...
-
PK Project Manager reacted to The Hat's post in the thread Picture Of The Week (POW) Information and Submissions with Haha.
Na.. The boat is not quite centred… Timing……:oops::lol:
