Epson R280 prints directly on CD but image is badly out of alignment

[boobear]

HI:

I've had this printer about 18 months and right after I got it I printed a single CD just to see how well it worked. It worked GREAT...... THEN!

Now, the CD's label is printed BADLY off center I'd say around 3/4 inch. I've looked all over Epson's as well as other support sites for any previous report of this problem; no help there.

Anyone here seen this or otherwise know of a "fix".

Thanks

Boo

 

[jflan]

Welcome to Nifty-Stuff
My *mind-reading module says that you are using the Epson software to control the disk printing process.
See here :
http://club.cdfreaks.com/f123/epson-print-cd-program-question-205558/
If that doesn't help, junk the Epson PrintCD software and go with Acoustica or SureThing.

*Websnail,
Your mind-reading module is great stuff, but it can be bit quirky at times

 

[boobear]

Welcome to Nifty-Stuff
My mind-reading module says that you are using the Epson software to control the disk printing process.
See here :
http://club.cdfreaks.com/f123/epson-print-cd-program-question-205558/
If that doesn't help, junk the Epson PrintCD software and go with Acoustica or Surething.

Sorry for being less than verbose in my first post...... I was using SureThing when I had the problem. I dropped back to the Epson software that came with it and it works fine.

The problem is that SureThing does not recognize the R280 as an installed printer on my system (who knows why??)

I will check out the link you mentioned and will also check Surething website.

Boo

P.S. GREAT site here.