Search results

ok thanks I'll have another look/try

hi guys I have new canon ix6850 printer which does 12 resume flashes alternating with the power light. The head starts to move a little around the suction pump area when turned on then gives up and does the flashing thing any ideas???? thanks

**Update** The little spikey rollers were infact clogged with icing turned black not rubber as first thought, I noticed when I placed them in water and the icing/dirt dissolved away. I gained access to these rollers by cutting away some access using a plastic welding gun to save stripping the...

guys, thanks for all the input I have stripped the spikey rollers out and painstainkingly scrapped off all the rubber will see how it goes tommorow see the piccy roller on left cleaned of rubber and roller on right not cleaned yet. These spikey rollers run across the surface of the print and...

hi guys I found the reason for the streaks, see piccy the out feed spike rollers have picked up the rubber of the rubber rollers ???? any one know how to prevent this or where to buy new ones, although i assume the rollers will be no good aswell? happens after 1000ish prints maybe less

Thankyou for the reply I was using the refillable crystal food cartridges but found myself having to refill 3 sets every single day and have saved so much time with the ciss

hi guys looking for advice on the following I run several ix6850 canons with ciss, they run great for 2 months then..... I get vertical streaks towards bottom 1/3 of the a4 sheet I notice a puddle of ink on the long grey sponge that runs across the whole printer near the head (just to the...

thanks for reply, will have a play with the settings, its been a few days and I think the spikes are getting less with time.

hi guys I have brand new canon Mg5250, I have problem when I use decor paper plus icing sheets. The half dozen rollers on outfeed are spiked and they pick up the undry ink and put spike marks down the sheet with a bit of ink in them. Is this a case of using paper to thick or is there a...

Rip canon ip3600, now scrapped and bought shiny new canon mg5250

Thanks again, if I get anywhere over the weekend i will report back, but if I have no luck these great web links can help others, thanks peter

I read all the links, but i cannot find the drive switch, where might this be located on the printer there is several drive motors (I have all covers off) 21 times Drive switch error [C000] Drive was not switched properly. 1) Foreign material or paper debris in the drive switch area; remove...

Thanks peter amazing post, i searched high and low for this 21 flashes error having a rest from it at the moment will update soon thanks again

ok there is 4 positions the cog on the arm can go,,,,crazy???

bump I have checked many things near the print head drive motor on top right has a white cog on a arm that can go in 1 off 3 positions, which one do i put it in???, I must have dislodged it when I had it upside down

hi all I have an ip3600 printer and the orange light flashes 21 times (alternates with green), any help would be most grateful or service manual link. bit of history, I have done the waste tank reset and wanted to clean the waste pads so I cut a hole int the bottom of the printer (with a...