Search results

Levels attached. All but one clearly have more than 40% in there, but it says they're all too low. It probably went through this cleaning on the other unit, which is why they're not full. So far, I haven't managed to print a single page on either one! Good grief, that's a LOT of ink just to get...

Hello all, I've given up on the inner door issue on the one Pro-1 we have (see my other thread if interested), and am trying to get the other one going. After swapping the head and the inks into the second unit, it tries to print a test page but insists the following: "Support Code : 1360 The...

Unfortunately, I have no way of getting my hands on the purchase record for these units. I did try the idea to print a CD and then try again, but that didn't solve it. I'd like to try the other printer, but can't get the print head carriage into a position where I can remove it. Any ideas there?

Hello all, I have a new Pixma Pro-1 that is INSISTING that the inner door is open whenever I try to print. Trust me, it is not. This bad boy was given to me by another department, new in the box, although I think it had been sitting around in that state for some time. I got it all put together...

Hello all, Scott here, recording lab manager at University of Colorado Denver. I found this forum because I ended up with not one, but two Canon Pixma Pro-1 printers. Only one set of heads and cartridges, though. More about that on another thread. For now, thanks in advance for your collected...