ren262
Newbie to Printing
- Joined
- Apr 29, 2020
- Messages
- 2
- Reaction score
- 1
- Points
- 8
- Printer Model
- Canon Pixma Pro-100
Hello,
So I have a Pixma Pro-100 that is roughly 5 years old. It's had pretty regular use up until about a year ago. Never had an issue. I pulled it out to use again last week after a little over a year of no use. I do a nozzle check and I'm not getting PC, M, Y or PM showing at all.
I pulled the head out and let the lower part sit in water over night, dry it out all the next day, try again, same thing.
I try another method I saw in a youtube vid where you blow compressed air into the nozzles. No change
I last tried leaving the head sitting in an ammonia cleaner over night, dried it out again and same results.
Is there anything else to try or is it junk now?
FYI, my black ink just ran out on this last test I have scanned and attached. Don't have a replacement atm
TIA for any help
So I have a Pixma Pro-100 that is roughly 5 years old. It's had pretty regular use up until about a year ago. Never had an issue. I pulled it out to use again last week after a little over a year of no use. I do a nozzle check and I'm not getting PC, M, Y or PM showing at all.
I pulled the head out and let the lower part sit in water over night, dry it out all the next day, try again, same thing.
I try another method I saw in a youtube vid where you blow compressed air into the nozzles. No change
I last tried leaving the head sitting in an ammonia cleaner over night, dried it out again and same results.
Is there anything else to try or is it junk now?
FYI, my black ink just ran out on this last test I have scanned and attached. Don't have a replacement atm
TIA for any help