thebestcpu's latest activity

I am a hobbyist, so the volume of prints is relatively low. In these cases, one must look at the total number of final prints produced...

Hi @ergaster I do have a p900 and am familiar with several failure modes, yet I have not had that particular one you experienced. It...

That’s a much sounder and safer option, your printer will benefit from this option also..

I forgot to mention a couple of other things: 1) When you do borderless printing, since it is not exact, the part of the image that...

Borderless printing needs some provision to catch the overspray; there is a piece of absorbant underneath the print path . That's the...

for which format do you need the borderless option - 10 x 15 cm or A4 ? This narrrows down the model options pretty much. You may look...

That is one of the few "office-type" printers that meet your needs at a lower starting point with higher cost cartridges. I was curious...

Thanks, a lot to think about

I will let the refill experts give you inputs on that and it may depend on the particular printer cartridge. A few things to know...

Thanks, I’ll have a look 😊

There is a series of Canon Maxify tank printers - the GX series starting at the GX1051 model - all running with pigment inks. That's...

Thank you, I’m not bothered about photo quality 😊

Hi @Emt There are not too many printers that are full pigment and EcoTank I found two yet have never owned either one. Here is a...

Well I tried it again with the AI generated Pic from @thebestcpu, and this time it looked a lot better but no cigar.. I may never get...

I have never done 3d printing, so it's quite the challenge to get the picture of Ted that will also render in 2D. I like your title...