pharmacist's latest activity

OK here is the second test using a different paper/ink/printer combination: Action Glossy (cast paper) on the ET-8550 dye ink printer...

As much as Epson is using the same printhead across a wide range of printers they'll use as well the same scanning hardware across a...

I have printed the target on a cheap cast paper of Action with the ET-8550, which should give a different 3D plot. I will redo the test...

Redoing the test with an earlier printed target on another paper type: First on the ET-8550 scanner: Secondly on the WF-7840...

I have to test this, but my first impression that by chance I tried to make a profile with PrintPrism with my unsupported Epson WF-7840...

That is strange: I tried to use my Epson WF-7840 scanner if it would give a good profile (officially not supported) and to my...

OK good to know. So you use the ET-8550 scan engine of the PrintPrism to generate the profile. Maybe Mike Chaney would be pleased that...

A cheap scanner supported by PrintPrism is the Canon Lide 300 (about 70 euro).

@ohtoulouz Here I have a 560 patch target for the CR30 that needs 2 sheets of A4 to be printed and should be more accurate.

No, I generally use Relative colorimetry with BPC. To be honnest, the result is quite good with your target. Maybe, I'll try to refine...

Colormunki works perfectly without any problems with the ccStudio or i1Studio software, no reason to pay for the latest software: it...

Did you tried a different rendering intent like perceptual intent with BPC enabled ? Normally 300 patches will already do a good job...

I would start with my 300 patch target. I have tested the profiling making with 3 printers: dye printers like the Canon TS705 and the...

spectral band between 400-700 nm is almost the same as the much mor expensive i1Pro2: 380-730 nm. The reason why this small device does...

Hello, I got a response from CHNSpec about various questions I had about the CR30. Here it is: "- The CR30 will display a red light...