pharmacist's latest activity

Why does the PC and the C band has the same hue. I would thought the PC should be lighter than the C band and also the M and LM looks...

If you still have problems because the jig/guider is too narrow (because your 3D printer cannot print the large version), try this patch...

What is the pattern of the nozzle check of your Pro-10 to start with ? Could you upload a scan of this ?

If you’re a colour management expert.. Then don’t read any further..:duc I have been reading here over the past many months on how...

I just upgraded the previous patch set for i1Profiler, because I have experienced reading problems at a specific row with two patches so...

The command is correct. D50 is considered the standard. Using the D65 is way too cool. Try to calibrate your monitor too with the D50...

Yes you can no problem at all. Here is a adapted version that is not to broad for your scanner/guider. It has 675 patches based on the...

just try the file above and see if it works for you (shrinked version TC9.18).

ok thanks for the new ruler but i will need to fix my 3d printer before i mean not in the long side, but in the sort side, anyway my...

Meanwhile I have shrinked the target a bit in order to fit your smaller scanning guide. BUT you have to move slowly now in order to pick...

My scanning eye opening is 25.5 cm wide, so not sure how much the width is of your scanning jig ? Here is a new design I made. I hope...

The area is exactly 22.3 cm as my design takes into account the scanning eye will start en stop on white paper and in between the row...

Tell me first the maximum distance you have between white and white area using the ruler and tell me the distance for example 24 cm, so...

Standard printer profiles are using the D50 observer at 2 degrees (1931_2) thus: colprof -v -qh -i D50 -o 1931_2 -S AdobeRGB1998.icc...

If you have an EU version XP-15000 then the resetter will reset both original as well as aftermarket on-time reset and auto reset chips...