Recent content by Manu

Hi, I didn't explain myself well before. With the V5204 service tool, the ink absorber counter is reset to zero, with the Canon Pro 100 and Canon Pro 10 printers (which are from the same generation).

Hi, PRO-100 and PRO-10 printers, which are from the same generation, have been shown here to enter service mode with, among others, the V5204 service tool and firmware V1.x. Searching the forum you can find it. If it doesn't happen in your case, it may be (I'm not 100% sure), because you have...

And the printer model does not appear

Hello, 2 things, 1º The Service Tool St5204, and surely others, they will not work with the change of hardware of how the equipment was when the purchase of the application was made, and between another hardware to the HDS, if they are added or changed. Recovering the original configuration...

Hello, the way i put it on service mode was press and hold the cancel/resume button, then press ON button, led will be white. Whilst holding down ON button, release cancel/resume button and press 5 times,with each press of the cancel button the white and amber leds light up intersperse, leaving...

Hello, a the service tool is the V5204 unlimited use for a PC, it is on ebay. To access the printer is explained in the detailed page: https://www.printerknowledge.com/threads/canon-pro-100-cabinet-removal-procedure.14918/#post-129909

Good information, thanks.

Hi palombiam, from an image from the previous post (in which you can see the Wi-Fi module), I am almost sure that it is the same as the Pro 10S, only that in the image the battery and its housing are already disassembled. In my case I have disassembled the Pixma Pro 10S to put a printer potty...

Hello everyone, following the detailed instructions on this page: https://www.printerknowledge.com/threads/canon-pro-100-cabinet-removal-procedure.14918/#post-129909 The post shows well the hook tabs that have to be pricked with screwdrivers to remove the covers. When separating the upper cover...

Hello The Hat, in this forum I have learned a lot and I hope to continue learning.

Hello The Hat.

Kaixo Artur5, Maybe the Pro10s needs 5 presses to enter service mode and the Pro10 or Pro100 only 4? I don't know, I have not tried any other combination.

Hello palombian, my version looks the same.

Hello, I can only tell you what I do, and I have reset the printer with 5 consecutive keystrokes.

Hello, I've seen the good post from The Hat, but if you could put pictures of the different things from the Pro 10 printer opening, that would be fine.