I managed to find the reptetive defect list for the 1300.
You need to measure the distance between one horizontal line and tthe next.
if the distances is;
75mm - Drum
37mm - Mag developer
37mm - PCR
56mm - Upper fuser
62mm - Lower fuser
45mm - Transfer roller
Hope this helps
Those grey vertical lines could be the PCR. If you take a look it might have marks all along it that match the ones that are printing. You could try giving it a clean with distilled water and a lint free cloth. It might help
Hey shield4life,
the damaged cartidge message definitely has more to do with a problem on the electronic circuit, or it also could be the temperature sensor. Either way, you can say probably say goodbye to the cartridge.
If you still want to open the cartridge, (I recomend it if only to see the...
Hi LinBillo,
You could try keepimg the STOP button pressed for about 15 seconds, or until you hear the carriage start to move. This often works, the only thing is it wont show you the ink levels for the cartridge afterwards.
Just in case anybody does come across this problem, I just took the chip off and the printer prints fine. It doesnt give me the toner level but this isnt so important.
As far as I could figure out, the problem was with the firmware version that the printer has.
Hi,
I hope this is the right place for this question.
I recently refilled a samsung clp-315 Black toner. The cartirdge was the one that came with the printer and I put a reset chip into the empty area that is usually used for this chip.
When I turn the printer on it still doesnt recognise the...