Top fill on the Epson 1400 and Artisan 725 using refillable (spongeless) carts purchased from mikling. It works well for me and I no longer get ink on my fingers at all.
Can anyone post a brief picture of where I look for entry and where the tube will be so I can set up the waste ink bypass on this printer?
Thanks in advance!
Jean
Sorry, websnail, but I had never heard of the Printer Potty. As a result of your post, though, I figured everything out thanks to Google and youTube; ordered aquarium tubing and tubing connectors; set up my own waste ink system using an old ink bulk ink bottle yesterday. Waited until today to...
Just ran the Epson utility and it tells me I don't need to run it because the ink waste pads are not full. Also ran the cartridge bank as if ready to refill, but got no weird noses either. Should I figure that it was a fluke? Maybe something WAS jammed and worked itself free? Or stay cautious...
Yes, I am in the USA. I did get the resset code from epson but now I can't find it in my Downloads folder. I have never done this before, but I am pretty savvy with computers. Given your warning, I would be extra careful and abort if I have an unanswerable question in the process. Skipping a...
Thanks for your answer santer. I just did ask you requested x2. The first time, it traveled left fine, but, on returning to the right, it made that terrible nosie again only not so bad as before. Then it continued it's cycle without further incidence. I repeated to see if it would make the noise...
Hi Everyone,
I haven't been on the forum for quite a while. I have been very happily using and refilling my printer. However, yesterday, as I was printing on my Epson 1400 I got that dreaded message about the insides needing help to which Epson's response is, of course, buy a new printer. I...
Conclusion: the printer needs a trip to the repair shop! Something major is wrong. Got the magenta printing through much ado in two steps: 1) rinsing both magenta carts with a warm water and ammonia mix, then running the purge file with that combo (though saw little improvement); and 2) even...
Think I figured this one out, at least for a little while. When I first installed the refill inks initially, magenta stopped printing. I just went back and used the HP Photosmart 3210's calibration "reset to factory defaults" and the resulting output has the heavy green color cast. A couple of...
I never had all the OEM cartridges so have not run it with them. The printer was given to me. Do you suppose there was a reason behind that? Yes, I bought a set of the refill friendly cartridges as well as the bulk ink for the printer. Pretty wild results, huh? The inks are all placed in the...
Does anyone have any experience with the bulk inks from printerfillingstation.com?
I ordered them pretty soon after receiving a used HP Photosmart 3210 printer so I don't really know if my problem printing photos is the ink, the printer, or the lack of hardware color calibration of my display...