Artur5's latest activity

I was refering to Maxifys with ink cartridges, not those awfully expensive models with tanks refilled from a bottle. If you were in...

Believe me, if you want to keep your sanity, stay well away from that printer. Take a look into the Core One section of Prusa's forum...

Honestly, nowadays I wouldn't know which printer to recommend, based on your needs AND within a budget of $150. I'm talking about Canon...

I bet that most of these would still be in working condition today if their printheads hadn't failed.

I have a still functional iP4000. CLI-8 cartridges can be used in stead of the BCI-6 cartridges, but if you want to replace a BCI-3e...

And painfully slow too. :rolleyes: If my ailing memory serves me right, my ZX81 had a memory module of 16KB, An astonishing value ,you...

Do you mean Bondtech's INDX or something like that ?. It sounds too good to be true, but I believe in that only when/if I see it working...

Error code 5b02 might or might not mean ink absorber full. Here is a list in German of Canon error codes. Here is a clip: 5b00/5b01...

BCI-6 ?.. I believe that there were references to those relics in some Egyptian papyrus dated a couple of millenniums BC

The long and winding road to 3Dland .. Voron for me, but I guess that one must be a bit nuts to choose this road, isn't so Redbrickman...

Your guess is as good as mine. An inside job ?. I'd say that, if it were so, Canon is rather sloppy protecting themselves from internal...

Three years ago I purchased from the same Ebay seller the service tool v5.306. It works fine on my Maxify. As PeterBJ says, for your...

That must be the only thing that they have in common..;)

I wouldn't bet on that, Maxifys are totally different printers from Canon Pro series. They have only the brand name in common. Besides...

I wouldn't use TPU for heat resistance. It's on a par or worse than PLA.