Artur5's latest activity

Nice design ! If I had to print this part, I'd choose a filament slightly flexible and with good outdoors endurance like PETG or ASA...

I put new handlebars on my bike. They aren't as wide as previous, so I'm out of space to mount my gear, except for the "thicker" bar...

Mine too, but I confess printing only the plastic parts and reusing the steel springs from broken pegs purchased at the store. :rolleyes:

I think "Permanent Chip" could also mean that the chip doesn't count down, it constantly shows full. These chips are intended for use...

I wonder if that applies not only to @The Hat but to all of us.. For instance, I plead guilty of printing clothes pegs for hours at a...

Maybe that is why you you are off your rocker, has it made you even more crazy than you used to be? :lol::weee:hide

ARC and permanent chips mean the same,. Once the ink level reaches empty, after the printer is switched off/on, ink level resets to full...

Take good care of your printers. In a few years, they will be the last survivors of the Bowden extruder species. People will pay a lot...

You seem to be on the opposite side of the counter, if you know what I mean :p Come on @The Hat, you know well that we're not talking...

There's the question of the nozzles too, Nifty. Those made from brass, copper or hardened steel may release small particles of different...

I don't follow you here.. Why do you think it's more difficult to feed filament in direct drive extruders ?. Have you tried?. I assure...

I guess that @Redbrickman wanted to sell you one of his "dozens" of Vorons..;) Good points about PLA. If your lamp has resisted for...

Good luck convincing @The Hat to replace his beloved PLA with another filament.. :p

I'd be very careful using anything 3D printed in direct contact with food/medicines. Even if PLA is often advertised as a health safe...

My five cents on what to expect from HT-PLA ( PLA-GF would a more accurate name ). As they say YMMV. Glass fiber filaments are VERY...