Recent content by Anthonycano_2013

  1. Anthonycano_2013

    How to remove PRO-1 printhead ?

    Guys, you have no idea how much I appreciate your help, I will contact canon service for an estimate price to fix it. Next step keep printing until the CO get replace and see how it goes, if it gets even worse than already is I'll purchase a new head from France, around 150 euros. Does anyone...
  2. Anthonycano_2013

    How to remove PRO-1 printhead ?

    I see, so in this case it means that because it isn't a clog, and it is a mechanical problem I can still use it. It may not be at 100% but 90% right? I may be okay with it. Thank you
  3. Anthonycano_2013

    How to remove PRO-1 printhead ?

    Hello @The Hat, I understand. So what do you recommend in this situation? Install a new print head would fix the problem, or should I contact canon for a farther diagnostic? Thank you for your time:)
  4. Anthonycano_2013

    How to remove PRO-1 printhead ?

    Hello @stratman, MBK and CO are looking alike, I wouldn't say there are three lines, it is more like a 1 centimetre line in the middle. CO has those vertical lines when the print is fresh, but then it dries out and almost disappear. The previous owner was using third party cartridges. Thank you...
  5. Anthonycano_2013

    How to remove PRO-1 printhead ?

    Hello @The Hat: finally I got the time to follow your steps, I did a cleaning cycle on all the nozzles, then a nuzzles test, but it was just the same as before. 24 hours later a cleaning to the nuzzles with the problem(MBK, C, R and CO), still the same as the very beginning, apparently is...
  6. Anthonycano_2013

    How to remove PRO-1 printhead ?

    Thank you @Artur5 @The Hat Sorry to thank you so late, I appreciate you took the time to answer. I will get the ink that is low and do the deepest cleaning on the system. I had already done some mild cleaning to test the nuzzles. Hope the MBK is fine. Will keep you post Again thanks
  7. Anthonycano_2013

    How to remove PRO-1 printhead ?

    Thank you @The hat👍🏼 You are right, one of the ink was low, actually pgi-29 M. I did find out about the nozzle pattern when only this one was low, then I did a cleaning cycle and a few nozzles test. Then PC, LGY, and MBK got low too, M is empty now. Unfortunately I don't own a scale, but will...
  8. Anthonycano_2013

    How to remove PRO-1 printhead ?

    I apreciate, thank you
  9. Anthonycano_2013

    How to remove PRO-1 printhead ?

    Hello, I am new here, I would love to get some advise from you @The Hat. Thank you for helping us all. I bought a second hand (pro 1) a few weeks ago, I did a nozzle test the very next day and everything was just perfect to my eyes, one week later I got this lines on my DGY, MBK, C, and CO...
Top