Latest activity

There is a YT video which may relate to your problem, it is slightly confusing ; it mentions the timing strip to be cleaned.

A service manual would explain such error code; https://www.sdott-parts.com/epson-l7180-l7188-et-7750-service-manual.html There may...

Is you account a local administrator? A few years back, MS did changes that will prevent a non admin user to install drivers for a...

got this , and dont know what to do . Tried the "shut off power switch on again " ....no use it loads does its thing and then the screen...

Thank you all for your help. A genuine Magenta cart and a few deep cleans has solved the problem, it's now printing beautifully. I'll...

Thank you all for your help. A genuine Magenta cart and a few deep cleans has solved the problem, it's now printing beautifully. I'll...

Hi I am looking for 350 gsm COATED paper/board (on both sides) that is suitable for the Epson EcoTank ET-8550 / EcoTank L8180 (same...

Fair point on TPU, though from what I’ve seen, its heat resistance is still a bit better than PLA... usually around 60–80°C vs PLA’s...

I’m having a tough time finding a second supplier for cardstock at the moment. I use Thepaperbox 350gsm Silk white cardstock for my...

What about printing a strip of TPU maybe 5-6 layers high and glue to the part where it clamps on the bars?

I wouldn't use TPU for heat resistance. It's on a par or worse than PLA.

LOL, It has an embedded nut on one side for a nice fat bolt :) Actually, I'm testing the fit in PLA, but I'm going to probably end up...

PETG would certainly be more robust as it has a little bit of flex in it, however I'm sure it will do the job and if it all goes pear...

Nice design ! If I had to print this part, I'd choose a filament slightly flexible and with good outdoors endurance like PETG or ASA...

Ah Ha, the big question is.. Did you use a metal bolt or a plastic one ? I know what your answer should be.. :)