Search results

Has anyone got instructions on how to remove and replace the printhead if I go that route. I think I can do it. I have quite a bit of experience in this realm, enough to know that I can easily mess up if I don't have good directions.

Is it ever a bad electrical contact? Is it worth removing the printhead and then reseating it??? Wild thought

Thank you for your reply. At least I know to not waste any more time or money on it.

Hello. I have a test print like Panos up above. The difference is it is in the third zone and not the second. All of that zone has in each section a different print for top and bottom. What goes wrong in the printhead to cause this? Can it be cleaned? I have done some cleaning cycles to no avail...