x64's latest activity

Did you check your waste cartridge too? Maybe it is defective or not seated properly. From what I could find the B801 error is a...

On the contrary, because I can see the big benefits this Ht Pla can bring to a project that is exposed to a bit of high heat once in a...

I’m not saying anything against this particular filament, because I haven’t tried it, but in the past I had negative experiences with...

Looks interesting, although I am curious what additives got used to give the material these properties. I think PLA is great for being...

I've had some experience with both Bambu Lab and Creality, personally would go with Creality for a cheap learning experience for...

I think the Colormunki/i1Studio/Calibrite method using the 50 + 50 patch method is actually based on these findings. The difference is...

I made another test to compare profiles with based on different patch sheet counts and the impact onto actual prints. I did this - - I...

I have been using that scanning table and slider for a while and I'm not impressed by it. The board itself is fine but the slider is not...