Tony4597's latest activity

👍 I agree, they are after all very cheap and cheerful and probably performing within spec which is ±5%RH. It was just my OCD kicking in...

Those little meters are pretty darn close, after all the amount of discrepancy between them is nothing, besides when measuring filament...

Thanks for the info. TBH I had never considered calibration. Will check out the video later 👍 Like you the 3 cheap ones (Aliexpress)...

You could calibrate your hygrometers using the salt method. See this video. I've noticed that some cheap electronic hygrometers I...

Thank you and yes I have a couple of filament dryers. I also purchased some vacuum bags and a pump specifically for filament. So along...

Keeping your filament reasonably dry is the best way of getting perfect prints every time, I have printed with my filament at about 50%...

My Ender3-SE printers were printing at ridiculous speeds when I first got them, and with plenty of help from here got them down to a...

Thanks, damp poor filament my first thoughts as well. Perhaps a combination of factors including the silly speed (Bambu's Ludicrous...

Looks like damp or bad filament, which seems likely if the same part printed successfully with the the Sunlu.

This is the worst looking print I have ever had. Of course over the last years I have produced my fair share of poor quality prints...

Obviously not having this type of experience directly printing with PLA I can only hazard a guess what the issues may be. I do not...

Sorry to hear you are having issues with brittle filament and breakages. I am sure you have probably looked into it but from what I...