Recent content by sarond

I'm not sure whether the Pixma Pro 9000 has the same service codes as the IP4200 but from the service manual an error 5110 could be a Carriage lift mechanism error with the following parts that may be the causing the fault PR lift shaft assembly Sheet feed unit Logic board assembly Carriage...

Have you tried holding down the resume button for over 5 seconds? You need to do this to disable the error for the current tank that is giving the error (and also ink monitoring on that particular tank). This will probably void your warranty as well. Also make sure that there is nothing...

Hi all my printer is going again. Not sure if this will help anyone else but this is what I believe might have caused the problem. FYI all tanks are skyhorse brand separate clip and tank design. The PGI-5bk tank seemed to block the led from being detected. This brand of tank has a bit of a...

Thanks Websnail, as usual very helpful info, this forum is a wealth of knowledge. I will try your suggestions to see if anything helps. The problem is the printer is only 2 months old so I hope it doesn't need a replacement head yet as the warranty will be void now. BTW I have an IP4300

I have the same problem on my IP4300 where I get 15 orange flashes and won't print anything. This is the error I get "Ink tank errors have occured. Open the printer's cover and replace the ink tanks on which ink lamps are off." I have refilled all tanks and gone through the "press resume for 5...

Hope this is not too late, I have been contemplating getting these http://www.ecbinkjet.com.au/CCB3.htm They are a separate tank and clip design, this way you only have to transplant the chip once. I think they are Skyhorse brand. This may not help you as they are in Australia.