Recent content by Printerz

@Anas BENJELLOUN, Dear Anas, On a SureLab D3000 I do have exactly the problem you describe. Nozzles check is fine, but there are lines like you show in your picture. How did this end? So what was the final solution? Thank you, Printerz.

Thank you for the reply. Is there a special software needed to perform the Service Calibration Routine ? I have seen the adjustments you can do in the Maintenance Utility, however, this does not resolve the problem. Thank you. Printerz.

Dear Purnomo, I do have EXACT the same issue with my Epson D700 Printer. Head replacement and now facing details and having a little bit magenta ghosting lines. How did you solve this? I'm very excited to hear from you. Best regards, Printerz.