Recent content by overstay2057

While you may be right, the other jig spaces the colormunki 2.0+mm away and it seems to have caused some slight issues There is a rubber piece on the CM you could probably remove get the gap closer. But I think at <0.5mm it is a pretty small gap. Spot check might be worth checking out. I should...

Hello, I created this Jig for the colormunki photo, since I didn't like the current designs. With this, there should only be a 0.5mm gap between the photo and the bottom of the colormunki (hopefully not affecting readings too much). However, the profiles I am getting have a yellow cast to...