Hi,
I needed to remove the printhead from my TS705 for cleaning and I thought it would be similar to my old printer before finding the correct way.
Anyway, I ended up removing this part...
From here...
And now I can't figure out how to put it back on (I don't think it's broken)
Any...
Trust me, there is very little space, I can barely even touch the top of the shield. I'm only able to lift the tab on the right using a flathead screwdriver, I can't even see the thing you're describing on the left.
Is there perhaps a way to remove the top casing of the printer?
Thanks
Thanks @PeterBJ
I think the problem I'm having here is I have very little space to get my hands on the shield, this printer doesn't have a scanner that you can lift up further to get better access.
Thanks
I fear I might have to just live with this problem.
I tried lifting the tab and although it does lift, there didn't seem to be any resistance at all, like it wasn't holding anything.
I did try to slide the guard over to the left, even to the right, but there was no give in it at all.
So either...
Hi,
I tried to access the timing strip but I just can't find this release tab!
I've taken a close up video just in case it helps you to give me any further advice?
Thanks
https://drive.google.com/file/d/12lTzM0N9UaLghUcpOtSiI5Vhnwx9TFoT/view?usp=drivesdk
Ah! It would be wouldn't it!
I'm not sure how easy that might be to remove without damaging anything.
I've done a print head check. Don't know if it helps narrow down the problem?
Is there anything else I can do to be sure what the problem is?
Thanks again