Nifty's latest activity

I just use Desiccant bags in my filament box which I warm up when needed on the nearest radiator for a few hours, and it seems to keep...

Guys, if you intend to print solely PLA or PETG, a food dehydrator is just fine, although dedicated driers are in general more...

I have a cheap circular food dehydrator with cut out trays that will take 3 1kg spools and go up to 70C. I use it on most new spools...

Looking at all the videos you have line up, I reckon you don’t need any more convincing, your already sold on your particular choice...

It's been a while since we've had this discussion. And I don't think we've had any long threads about this. What are y'all using as...

The following video seems to be a very honest appraisal of the prototype Snapmaker U1 Lots of software issues to be sorted but fo rme...

I already had this box of springs from Aliexpress. I made the holes they fit in snug so they don't fall out. I had a strange problem...

You can still do that, you're just going to have little offsets in heat/purge times going between, say, PLA and PTEG (220c and 240c...

That's fantastic! I've printed a handful of different battery holders and connectors. Some using stripped wire wrapped around a...

Some lithium rechargeable AAA batteries were delivered today. I want them for things that don't work well on the lower voltage of NiMH...

Not bad. Ironically I just watched this great review of it earlier today: Ya, I've wondered about that with the H2D to mix very...

I'm looking at a multi setup too. I was actually ready to pull the trigger on Flashforge's AD5X, (and the wifey is on board). BUT. I'm...

Ok friends,I've been around and around and around about this forever! I'm usually (at a fault) frugal <cheap> and have a hard time...

Crazy interesting idea! Printing 2-part resin/epoxy for silicone?!?!

I'm still refilling my Canon Pro-100. It's 11 years old now but super reliable. I don't use it so much these days now I'm retired but...