Recent content by mobbarley

Hi everyone. Unfortunately it took me a while to get around to it, but the printer is now fixed! Using canonfodders idea of pulling the power while the rollers were up I was able to see a foreign object under the white rollers while shining a torch through the rear flap. I removed the top...

hey fodder, thanks for the info! I see what you mean about the rollers lifting when you turn it on, mine do too. On closer inspection all the rollers are pushed down except for #3 and #4 from the left. They are slightly lifted and can be turned by hand. I assume that something must be jammed...

Hi all, I have a reletively new IP4200 which has just started to jam! Looking behind the print head there is a series of 8 white rollers. Paper scrunches under the 2nd from the left, whether it is from the feeder or cassette. I cant turn the left hand two by hand where as the middle ones can...

Hi Grandad, This is what I suspected. I have removed the tape and they are installed properly, however the is only a slight tinge of colour when I remove them. I dont have any original ones to try. I have tried blowing on the vent hole as well, had little effect. As I dont care about the carts...

I have an IP6000d which has been sitting around for about 6 months doing nothing. Ive tried to get it going with set of generic inks before I purchase a CIS system. Doing the deep clean and nozzle check I got the test pattern to about 90%, but there were a few stubborn nozzles so I decided to...