Recent content by ferny

I posted a video in this thread back in April. I have since gotten instructions from trigger37 that helped me take apart the whole printer (and it was a pretty big job), and found that there was thickened ink down in the pads that was blocking up the output tube. I cleaned the pads (wish I had...

If the waste ink tank is overflowing, is that easier to fix than if one of the internal tubes came loose, or is it essentially the same amount of disassembly? I don't know how to reach trigger37. I hope he responds to my post or email, as disassembly looks potentially destructive if I don't...

Does it look like this: http://www.youtube.com/watch?v=H17UBG3X8Cc ? I just developed the same problem on my too-expensive-to-replace MP960 (a large part of the cost being all the spare cartridges I already have purchased). I am currently looking for instructions on how to disassemble as...

I have uploaded a video of the ink bubbling/spurting out on YouTube: http://www.youtube.com/watch?v=H17UBG3X8Cc The video is showing the section about 2 inches from the right side of the paper tray. The bubbling you see actually sends small drops of ink all over the paper tray and even past...

I have a very messy problem, which I am beginning to think is the end of my MP960. It has started to spurt its PGBK5 ink out of the paper exit slot, to the right of center. It gets forced out when the printer is prepping for printing or doing a nozzle check. You can see it bubble out in...