chaos_engineer's latest activity

If you have not found this site you may like the content and the explanations of the finer settings. IMHO worth a look around The 6...

Can you print some anti vibration feet for it to help with the shaking? Use your old printer and run them in TPU. See if that helps...

Are you close to a Microcenter? Phx store shows them as sold out, but they do stock them.

Can confirm, H2S is not in the current stable build of Orca

Have you pulled the trigger yet ? I am considering an upgrade to the H2S for the bigger build volume and the added bells and whistles...

That pretty good new, thank you.. :thumbsup

I've been having pretty good success with PLA+. Seems to fail less, stick better, and print smoother (so far).

Looking at all the videos you have line up, I reckon you don’t need any more convincing, your already sold on your particular choice...

You can still do that, you're just going to have little offsets in heat/purge times going between, say, PLA and PTEG (220c and 240c...

Not bad. Ironically I just watched this great review of it earlier today: Ya, I've wondered about that with the H2D to mix very...

I'm looking at a multi setup too. I was actually ready to pull the trigger on Flashforge's AD5X, (and the wifey is on board). BUT. I'm...

Ok friends,I've been around and around and around about this forever! I'm usually (at a fault) frugal <cheap> and have a hard time...