Recent content by Braddie149

  1. B

    How to remove PRO-1 printhead ?

    Thanks for the response guys, ive been chewing it over & may well decide to save up for the Pro 300... I'm slowly going off the Pro 10S due to it's age, i think i'd rather spend extra & have the peace of mind a new printer will have warranty.
  2. B

    How to remove PRO-1 printhead ?

    Hmm, food for thought Ok, if you had to choose between a used Pro 10S or a new Pro 200 - which one & why? Just after a bit of guidance from more knowledgeable people than me..
  3. B

    How to remove PRO-1 printhead ?

    Yeah i appreciate the Pro 200 is the older 100 replacement, but it seems to get good reviews, plus buying new will get me a guarantee. Does the 10s not have the same B200 issue or was that more on the Pro 1 The 10S still seem to fetch reasonable money considering it must be a few year old...
  4. B

    How to remove PRO-1 printhead ?

    Thanks for the reply All carts are genuine Canon, the doors won't drop down due the error. So i'm guessing it's not worth pursuing this error any further & think about a replacement? What's the consensus on a Pro 10s v the new Pro 200 / 300 model, although i think the 300 may be too expensive...
  5. B

    How to remove PRO-1 printhead ?

    Hi, im new to these forums & looking for some advice A few days ago my Pro1 was working fine, one of the ink carts needed replacing, so replaced with OEM I did a couple of test prints which were fine, then all of a sudden it started flashing orange then white 10 times each. I realise this is a...
Top